- FM Radio Transmitters
- High Power FM Transmitters
- Medium Power FM Transmitters
- Low Power FM Broadcast Transmitter
- FM Amplifiers
- Portable FM Transmitters
- FM Broadcast Antenna
- RDS Encoders
- Receivers & Re-broadcast
- DAB/DAB+ Transmitters
- Dab Antennas
- AM Transmitters
- SW BROADCAST TRANSMITTER
- RF Connectors and Coxial Connectors for Broadcasting
- FM Antenna System Package
- STL Link Antennas
- Radio Link Antennas
- Radio Coupling Cables
- FM Power Splitters
- RF FEEDER CABLES
- Motorized RF Switch
- RF Dummy Load
- FM Combiners
- FM Cavity Filter
- Remote Control
- RF Switches
- Hybrids Directionals Couplers and Starpoint joints
- FM Isofrequency
- Reportage Unit
- Radio Accessories
- STL Link Radio Studio to Transmitter Link
- Radio Links
- STL Link Amplifier Microwave
- Pattern design & network Planning
- Complete FM Transmitters Packages
- Used Broadcast Equipment
RF Transmission
Showing 169–180 of 287 results
TRANSMITTER AM COMPACT 1000
1kW AM Transmitter
Output Power 1000 nominal watts Load Impedance 50 Ohms unbalanced Frequency response +/- 0.5 dB between 40 Hz and 10 Khz Harmonic Distortion less than 1.5% at 90% modulation, measured between 40Hz and 10Khz Modulation Capacity Better than 140% at positive peak at 100% of Nominal Power Carrier Amplitude Shift Less than 1% Radiation of Harmonic and Spiral Signals Better than 75 dB below the carrier level Residual Noise Better than 65 dB Frequency Stability +/- 5 Hz or better Audio Input Level + 10 dBm nominal for 100% modulation Supply Voltage 110 VAC / 220 VAC with taps of +/- 5% and 10% 1 phase Power Consumption Typical efficiency of 80% for 100% of rated carrier power Operating Conditions Ambient temperature - 5ºC and 40ºC Relative humidity between 0% and 90%. Altitude between 0 and 3500 meters above sea level Size and Weight 80 Kgr. Height 84cm, Depth 60cm, Width 60cm
UHF B IV-V BROADCAST TV PANEL
The UHF Band IV-V TV panel with 1KW maximum capacity and 7/16″ type connector is a heavy duty panel with stainless steel dipole, hot dipped steel radome and reflector, PTFE insulators and stainless steel hardware. Suitable for high power systems with horizontal or vertical polarisation. Installed on all 4 sides of a tower, they determine omnidirectional radiation patterns, UHF panels can be manufactured for vertical or horizontal polarisation on request.
