Placeholder

On-Air light

Category: .

Product Description

On-Air Light

The On Air Lamp is a signaling device for use in broadcasting or recording studios.
The internal LED lighting does not need any maintenance. It is possible to fix the lamp on the ceiling or on the wall with an optional bracket.

The ON AIR LIGHT is a light warning device easy to install

It’s available with customized words on request

It has no delay in switching on and That Can be hanged on the wall holder or as flag to Radio, TV and Recording; It is useful to warn the operators
That microphones are open or guests are broadcast live.

On-Air Studio Light

Technical specs:

LED LAMP
– Operating Voltage: 12 to 15 Vdc
– Current: 330 mA
– Controls: Dimming, through recessed trimmer
– Dimensions: 351 x 124 x 58 mm (without bracket)
– Case: Inox steel
– Weight: Around 1.5 Kg

POWER SUPPLY
– AC Mains Input: IEC, 110V or 230V 50 / 60 Hz, fused, 15W maximum
– Dimensions: 109 x 48 x 70 mm
– DC outputs: 3 x 12 Volt, blinking or permanent (jumper-settable for each lamp)
– Controls: 3 x TTL / 3 x Clean Contacts (photocoupled, jumper-settable for each lamp)
– Control current supported by each port: 10 mA max, 5 mA nominal. An internal 1Kohm protection resistor is fitted on series on each port.
– Connections: Terminal blocks (supplied)
– Controls: Blinking rate adjustment (recessed trimmer)
– Blinking Rate: From 3 flashes/sec to 1 flash/sec
– Main Features:Capable of powering up to three LED lamps at the same time

© 2016 Eletec Radio Broadcasting Equipment & Transmitters. All rights reserved. Design & Optimized by iGent Digital

Click Me